IstaBreeze 2000 Watt 48 Volt Hybrid Charge Controller Charge Controller
Havale ile ödemelerde %2 indirim
2000 Watt 48 Volt Hybrid Charge Controller iSTA-Breeze
istaBreeze®'s Wind/Solar Hybrid Charge Controller is an intelligent controller that simultaneously controls the wind turbine and solar cells. The high-end device can also be used as a monitoring system. It is used to safely and efficiently charge and control your battery with a Wind Generator / Solar Module combination.
With its rugged appearance, simple operation and integrated protection functions, this device features high efficiency and low load losses. This version of the controller will significantly increase the stability of all batteries, especially the life of the batteries.
In addition, the control electronics in the control cabinet monitor the system voltage and overvoltage.
Features and product information:
Use of external and high quality (Triacs & Hyper Mosfet) solid state components. It is to extend the life of the controller.
Microprocessor controlled charging with integrated voltage and current limiting.
Electromagnetic brake control.
Integrated 3-phase short-circuit switches (brake switch)
Protection against lightning strikes.
Protection against overcharge, deep discharge, short circuit, overload and false reverse polarity.
Integrated display
When the battery is full, the generator automatically brakes slowly. The modern braking system with external load resistor (Drain Load) to prevent the turbine from clogging immediately, extends the life of the stator.
CONSIDERATIONS FOR CHARGING CONTROLLER CONNECTION!!!
one. Install the charger close to the battery and in a place that is not hot.
2. Mount the load resistor (resistor) horizontally away from the battery and controller.
3. First connect the + ends of the battery and the charger, then the – ends, then connect the load resistor (resistor) to the load outputs and the 3 phase (ph) inputs from the last turbine.
4. Check that the terminal connection screws are well tightened.
5. Check that the charge controller inverter and battery pack are at the same volt.
6. To stop the turbine manually, you can use a three-phase short-circuit switch (63k automaton or 3x25 on-off pako) between the wind turbine and the charge controller, if necessary.
7. Be sure to ground the body of the pole.
8. The length of the pole can be around 6-12 meters.
9. You can mount the pole tightly with ropes from 3 sides against wind jerks.
10. While the charger is connected to the system, do not drill anywhere on the device with a drill. If you are going to drill for assembly, the device must be in the off position.
Teknovation Arge Bilişim Dan. Ltd. Sti. It was established by the Young Entrepreneur Electrical-Electronics Engineer Hamdin Bağçeci as a state-supported R&D company and continues its commercial activities in the field of Solar Electricity Generating Systems, increasing day by day with customer satisfaction.
In solar systems, we try to help our customers with the right product and the right price as much as possible.
A little warning to our customers. They should be careful about the unbranded, unlabeled Solar Panels removed from the power plants and the batteries that are trying to be sold as gel but are not real gel. We would like to share the information that such products are not allowed in our company. Of course, it is important to consider these when making price comparisons.